►36” high by 10 feet long with
10 gauge heavy duty curled skinplate.
►Trip moldboard design using four 5/8” diameter wire by 3-1/2” outside diameter by 22-1/2”
long heavy duty adjustable tension springs.
►15 degree blade attack angle with heavy duty base angle.
►Moldboard is capable of reversing 35 degrees either side of bull dose position
through two 3-1/2” diameter by 12” stroke hydraulic
reversing cylinders or manually reversed with lock out pins at
preset degrees.
►Six 3/8” thick moldboard
reinforcement ribs standard.
►Pushframe shall have a heavy duty 4” x 4”x 3/8” HSS pushbar spanning
three attachment points to the moldboard.
►Heavy duty 6” x 4”x 1/2” angle oscillator bar with 3/4” flame cut ears on 31” centers to allow the moldboard to follow the road
contours.
►Pushframe shall have integral brackets to mount caster assemblies.
►The moldboard trip action is
controlled by a center mount thrust rod which is
rubber cushioned to reduce stress during tripping.
►Moldboard backer angle punched to accept 12” centers cutting edges.
►2 Point level lift chain arrangement standard.
►Optional mushroom casters or 10” steel wheel caster assemblies.
"QUALITY by DESIGN"
EVEREST EQUIPMENT INC. 1077 Westmount St.
Ayer's Cliff, Quebec (Canada)
JOB 1C0
Tel: 819-838-4257
Fax: 819-838-5653
EVEREST
RESERVES THE RIGHT TO CHANGE PRODUCTS AND SPECIFICATIONS WITHOUT
NOTICE.
